Fix the cause first, then the paint: scrape loose paint back to a firm edge, feather and fill the edges, seal with the right primer for the surface, and repaint. Peeling usually comes from moisture, painting over glossy or dirty surfaces, or latex over unprepared oil paint.
It depends on the surface. For stains from water or smoke, Benjamin Moore lists its alkyd Fresh Start Undercoater and Primer/Sealer. For repaired drywall and patched areas, a high-hiding acrylic primer such as Fresh Start 046 seals the surface; the Gypsum Association's GA-214 recommends priming the entire prepared surface so patches do not show through.
When peeling paint tears off the drywall's face paper, the brown paper underneath must be sealed before any water-based paint or joint compound goes on, or it can bubble. An alkyd primer such as Fresh Start Undercoater, listed for drywall, seals it before skim coating.
In homes built before 1978, yes. Scraping old peeling paint in paid work falls under the EPA lead rule when more than 6 square feet of painted surface per room is disturbed, which requires an EPA-certified firm, containment and a verified cleanup.
Old plaster can peel because of moisture, previous coats of incompatible paint or a powdery surface layer. Loose material is scraped back, the surface is consolidated and sealed with a primer suited to it, and cracks are reinforced before skimming. In pre-1978 homes, painted plaster is a common place for lead paint, so lead-safe practices apply to paid work.
Joseph Assise III Painting is based in Easton and serves towns across eastern Pennsylvania and western New Jersey, centered on the Lehigh Valley. Town pages:
Allentown, PA | Bangor, PA | Bath, PA | Belvidere, NJ | Bethlehem, PA | Blairstown, NJ | Brodheadsville, PA | Califon, NJ | Catasauqua, PA | Center Valley, PA | Chester, NJ | Clinton, NJ | Columbia, NJ | Coopersburg, PA | Coplay, PA | Delaware Water Gap, PA | Doylestown, PA | East Stroudsburg, PA | Easton, PA | Emmaus, PA | Flemington, NJ | Forks Township, PA | Fountain Hill, PA | Frenchtown, NJ | Hackettstown, NJ | Hellertown, PA | High Bridge, NJ | Hope, NJ | Jim Thorpe, PA | Kutztown, PA | Lehighton, PA | Long Valley, NJ | Macungie, PA | Mendham, NJ | Milford, NJ | Mount Pocono, PA | Nazareth, PA | New Hope, PA | Northampton, PA | Oxford, NJ | Palmer Township, PA | Palmerton, PA | Pen Argyl, PA | Perkasie, PA | Phillipsburg, NJ | Portland, PA | Quakertown, PA | Riegelsville, PA | Roseto, PA | Sellersville, PA | Slatington, PA | Springtown, PA | Stockertown, PA | Stroudsburg, PA | Tatamy, PA | Topton, PA | Upper Black Eddy, PA | Upper Mount Bethel, PA | Walnutport, PA | Washington, NJ | Whitehall, PA | Williams Township, PA | Wind Gap, PA
Local guides with housing-age and climate data: Lafayette College, Easton | St. Luke's Easton Campus | Lehigh University, Bethlehem | SteelStacks, Bethlehem | Wind Creek, Bethlehem | Lehigh Valley Hospital, Cedar Crest | Dorney Park, South Whitehall.
No. Paint applied over peeling paint fails with it. Loose paint must be scraped back to a firm edge, the edges sanded and filled smooth, and the area primed before repainting. Otherwise the new coat lifts along with the old one.
Find and fix the cause: moisture, dirty or glossy surfaces, or incompatible paint layers. Clean and dull the surface, use a primer suited to it, and in bathrooms ventilate well and use a humidity-rated paint. Repairs without fixing the cause usually peel again.
Usually moisture: steam condenses on walls and ceilings, and paint over soap film or mildew loses adhesion. Clean and dry the surface, scrape loose paint, prime, and repaint with a paint made for humidity such as Benjamin Moore Aura Bath & Spa, then run the exhaust fan during and after showers.
In homes built before 1978, old peeling paint may contain lead, and dust from scraping or sanding is the main hazard. The EPA rule requires certified firms and lead-safe practices for paid work disturbing more than 6 square feet of paint per room. Avoid dry sanding old paint yourself.
Sources: Benjamin Moore Fresh Start Undercoater and Primer/Sealer (032) technical data sheet; Benjamin Moore Fresh Start High-Hiding All Purpose Primer (046) technical data sheet; Benjamin Moore Aura Bath & Spa Matte (532) technical data sheet; Gypsum Association GA-214, Recommended Levels of Gypsum Board Finish; EPA Renovation, Repair and Painting rule, 40 CFR Part 745 Subpart E. Figures checked October 2026.
Licensed PA126039. $1M insured. Free written estimates after an on-site visit.
Book Free Estimate Call (610) 252-1815